Whynter BUILT-IN ICE MAKER UIM-155 Manuál s instrukcemi

WHYNTER BUILT-IN ICE MAKER Instruction Manual MODEL # : UIM-501SS Congratulations on your new WHYNTER product.

10 OPERATION Final Check List before Operation 1. Have all packing materials and tape been removed from the interior and exterior of the ice maker?

11 How the machine makes ice There are two distinct cycles: Freeze and Harvest. Freezing: During the freezing cycle, the compressor pumps refrigeran

12 CARE AND MAINTENANCE Preparing the Ice Maker for Long Storage If the ice maker will not be used for a long time, or is to be moved to another pla

13 Periodic cleaning and proper maintenance will ensure efficiency, performance and life expectancy of the ice maker. The maintenance intervals list

14 distribution tube may be blocked. 1. Shut off the water supply. 2. Disconnect the water hose from the distribution tube. 3. Gently take out the d

15 Descriptions of LEDs and buttons: 1. Red LED: Ice Full indicator light. When this LED is lit, the ice storage bin is full of ice or there is som

16 TROUBLESHOOTING Many common ice maker problems are easily resolved. Try the troubleshooting suggestions below to see if the problems can be reso

17 To obtain service or information, contact Whynter via email at [email protected] or call 866-WHYNTER. Product contents and specification

2 TABLE OF CONTENTS PARTS AND FEATURES 3 SAFETY PRECAUTIONS 4 INSTALLATION INSTRUCTIONS 5 - 6 ELECTRICAL REQUIREMENTS AND INSTALLATION 7 - 9

3 PARTS AND FEATURES 1. Door Hinge 2. Door 3. Distribution Tube 4. Ice Mold 5. Water Trough 6. Float 7. Ice Bin 8. Selector Switch 9. Leve

4 WARNING TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY WHEN USING YOUR ICE MAKER, FOLLOW THESE BASIC PRECAUTIONS:  READ ALL INSTRUCT

5 INSTALLATION Remove packaging materials IMPORTANT: Do not remove any permanent instruction labels or the data label on your icemaker. Remove tape

6  When installing the ice maker under a counter, follow the recommended spacing dimensions shown. Place electrical and water supplies and drain fi

7 Electrical Requirements Before you move your icemaker into its final location, it is important to make sure you have the proper electrical connect

8 To remove door from hinges: 1. Remove the top hinge cover. 2. Using a Phillips screwdriver, remove the screws, then remove top hinge mat and top

9 4. Connect nuts of the water supply hose to tap and water inlet valve. Tighten firmly by hand, then one-half turn with wrench. 5. Turn on main wate