7
INSTALLATION AND OPERATING INSTRUCTIONS
INSTALLATION OF YOUR ICE MAKER
Locate the ice maker away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sun-
light may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold am-
bient temperatures may also cause the ice maker not to perform properly.
Plug the ice maker into an exclusive properly installed-grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord.
IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.
SPACE REQUIREMENTS
During transportation, the incline angle of the cabinet should not be over 45°
Do not turn the Ice Maker upside down. Problems could occur in the compressor and sealed system.
The Ice maker should be placed horizontally on a properly leveled surface.
To ensure proper ventilation for your Ice maker allow 6” of space at the back and on each side.
Before using the Ice maker for the first time, please wait 4 hours after positioning it.
Clean the ice shovel, ice basket, water reservoir, and ice scoop frequently.
OPERATING INSTRUCTIONS
1. Make sure that the ice maker is turned off.
2. Open the top cover and remove the ice basket.
3. Remove any dust or objects that may be in the water reservoir.
4. Fill the water reservoir up to the line marked “____”. Fill with potable or drinking water only.
5. Turn the unit on by pressing the Power button.
6. Select desired ice cube size by pressing the Size Selector (Small, Medium, or Large)
7. Water will be pumped from the water reservoir to the water tray under the freezing bars. The freezing bars
will start freezing. Once the freezing process is complete, the freezing bars will heat up to drop the ice cubes.
Then the ice shovel will push the ice cubes down to the ice basket.
8. When the unit is used for the first time, discard the first couple batches of ice.
9. The ice maker will automatically check the water level in the reservoir periodically and will stop the ice-making
cycle when the ice maker detects any shortage of water. The water indicator will then start flashing. Press
the ON/OFF button to turn off the unit and fill the reservoir with water. Press the ON/OFF button again to re-
start the ice-making cycle or wait 3 minutes after the water indicator stops flashing as the ice maker will begin
it’s normal operation cycle automatically.
10. When the ice cubes reach the ice full sensor, the ice maker will stop operating and the ICE FULL indicator
will be displayed.
11. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level. If unit is not in use,
drain all water left in the water reservoir.
NOTE: This ice maker produces 9 ice cubes every cycle of 10 to 15 minutes approximately de-
pending on the size of cube is selected. When the ambient temperature is lower than 59ºF, the small ice
cube size is recommended to avoid ice cubes clumping together. For best performance, water tempera-
ture should be between 55ºF and 85ºF and ambient temperature between 65ºF and 77ºF.
NOTE: The ice basket does not keep the ice cubes frozen. The ice in the basket will slowly melt and
the water will drip to the water reservoir and reused.
(12 stránky)
(11 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce